Reconstituted Tobacco Technology

Recon Process Slurry Type (Comas LA Design)

The By-Product generated from previous process as Threshing Line, Primary Line, Make & Pack, is now collected and used into a process that generate a foil very similar to the natural leaves of tobacco. The foil is than cut into strips for ease blending with other tobacco.

The tobacco by-products` blend is thoroughly mixed before grinding to particles size < 120µ, and then mixed with a adhesive natural gums. The tobacco powder mixed with natural gum adhesive powder is blended together with liquid solution, in such a way to form a slurry or dough/pasta. The tobacco slurry is than cast on the dryer belt by means of a roll coater system, or a laminator to form a sheet. Then dried to remove the excess water, cut and packed.
 

Our System Offer the following benefits

With our system all the tobacco material “Byproducts”(stems, scraps, dust, dust, etc.) at a specific ratio that reflect the inventory and meets the specific objectives of the final products can be used.

Unusually low natural adhesives addition such as (guar gum, tamarind or carboxymethyl cellulose).

Low water addition are required (in the Laminated process).

Unusual energy saving by using a steam-pans and hot air impingement dryers combination.

Up to date bio-cleaning working condition and, low downtime.

Functional space saving layouts and flexible attitude allow full response to any customers requirements as concerns specifications and capacity.
 

Pilot plant activity:

The daily activity of our “Pilot Plant” can provide customers tailored made “Samples” type cast leaf (slurry) or laminated (dough/pasta).



 

 

 

Bt_voltar
Victor Frederico Baumhardt, 1299 - Dona Carlota - CEP: 96842-500 - Santa Cruz do Sul - RS - Brazil - Phone: 55 51 37193277 / Fax: 55 51 37192949